REHOST OF Jumper: Opposing Forces


(NOTE: contains some gory graphics in World 5 and maybe the intro cutscene, much nicer outside of that)

The classic Jumper fangame you love and love now has a download link on a site that still exists! Not only that, but this site has NO sketchy malware whatsoever! And if that's not enough bang for your lack of buck, said download link is also completely free of viruses! (virodes?) It DOES force your screen resolution to 600x480 or somewhere around that, but it kindly reverts back to your main resolution once you stop playing it. The download link, Jumper OF.7z, is just above this text!

But what IS Jumper: Opposing Forces? According to the readme,
"Jumper Opposing Forces is created as a spin off from YoMamasMama's popular Jumper Games. Its taking time during the J1 timeline and puts you in charge of two different characters. The gameplay is very similar to what you are familiar with, if you have played any of the other games, so hopefully you will feel at home with it. Be warned though, the game is rather hardcore so it will be quite a challenge to run through it."
What that fails to mention is that it's also a crossover with Half-Life, and there's one area in particular with a lot of fictional-creature-gore in it. If that all sounds okay, then go ahead!

But wait, is all this still not enough? Really? Like, rea- an additional savefile with ALL the Get Ogmo stages beaten, SEVERAL Thief Mode stages also beaten, and ONE secret character unlocked is also available, so now you can have even more resources for the built-in level editor! Download it HERE BUT PLEASE DO NOT CONFFUSE THIS WITH THE DOWNLOAD FOR THE FULL GAME, WHICH YOU CAN FIND ABOVE THIS TEXT! Anyways, if you get more progress on that savefile, feel free to re-upload it in the comments! Yeah!

But wait AGAIN, I don't know if it runs properly on Mac/Linux, nor do I know if any Mac/Linux downloads exist. Sorry.

Upon downloading, extract the .7z file using 7-zip. Or go find and use PeaZip and in case this message is being viewed in an apocalyptic future where 7-zip has no official download site either.

TheMordeus, The_Freik, Erik Ambring, Lord Tomahawk, Dabomstew (original concept by Maddy Thorson/YoMamasMama)
Made For: 
An event

Cute Jump


This is a fan game of Matt Thorson's "Jumper" (http://www.mattmakesgames.com/). It is very difficult and a little bit strange.

This game was made with Game Maker 8.0, so it only runs on Windows, and is prone to crashing on Windows 8.

Made For: 
An event
Danni's picture

Grumper: Better Movement Edition


An attempt to correct what went horribly wrong with Grumper.

Main changes:

- Movement physics have been revamped to now have near-instant acceleration and deceleration both on land and in the air (though it's _slightly_ lower in the air still), as well as decrease max horizontal speed.
- Levels were tweaked a bit to accommodate the physics changes.
- The removal of selectable difficulty. This caused the experiment to break because everyone selected a different difficulty.
- A fix for the death location decals not actually getting limited to 100 on-screen.
- When you quit the game during a level, it still saves your death locations for that level.

Again, attach your stats-xx.txt file here when you're done playing.

Event Created For: 
Made For: 
An event
Danni's picture



Move with the Arrow Keys. Jump using Shift. Hold Jump to vary your jump height.

More info:

Grumper is a Jumper clone I decided to make after playing the newly fixed Linux version of Super Meat Boy for a while and then reminiscing about the classic Jumper games by YoMamasMama, and then wanting to design a Jumper-esque game of my own. I also made it because a while back, Sergio suggested I try experimenting with game difficulty by deliberately making the game easier or harder to play.

The game itself is quite like Jumper, although it uses Super Meat Boy-style deceleration (insta-brake while on land).
Unlike Jumper or Super Meat Boy, however, you can't double-jump or wall-jump.

- You want to get to the rapidly spinning portal on the other end of the level.
- Leaving the screen from ANY side will kill you, as will colliding with a spike ball. When you die, you reconstitute at the beginning of the level and any moving gimmicks will reset.
- The up-arrow blocks bounce you high (sixteen blocks high I believe). Normally you can only jump four blocks high. When you hit these blocks from the sides or from below, they act like a normal wall (that is, they don't bounce you).
- Red, green, blue blocks are toggle walls, which can be turned on or off by tapping the same color power switch.
- Moving platforms travel horizontally in one direction until they hit an obstruction, causing them to reverse.

The game is broken up into three difficulties: Easy, Normal, and Hard.

- Normal is the original set of 15 levels I created. The set starts off pretty basic with the first few levels, but gets pretty challenging near the end. Perhaps the difficulty curve is rather steep, but with only a small set of levels there isn't much I can do about that. Intended for most players (hopefully).

- Easy takes the Normal levels and makes most of the jumps shorter/easier, adds guard rails in some places (to prevent you from flying off the screen too easily), increases the coverage area of spring blocks, etc.

- Hard takes the Normal levels and increases the coverage area of spikes, shrinks a lot of platforms, and sometimes even forces you to complete a level in a roundabout way. Expect some rather tricky jumps. For veteran players only.


As you complete each level, the game saves statistics into a file on your hard drive. After you finish playing, look for a file in the game's folder titled "stats-16986802.txt" or something similar (the game will tell you exactly what the file is called). You can then select View Results from the main menu, choose this file from the selection dialog, and be able to view all the places you died, and how many times you died on each level. It would be pretty cool if you could upload the statistics file here as a comment attachment. That way I could see where people are dying the most, and just how difficult my levels are. Granted, the statistics are rather basic. They only include death locations, which aren't incredibly meaningful as far as determining where players are having trouble, especially in the more open areas. I tried addressing this a bit by adding in some spikes where you would normally just fall to a lower level on a failed jump. Still, I'm curious about this (and I don't feel like improving on the system - I'm kinda fed up with MMF2 right now as it is).

Note: Even if you don't finish the game (you give up on a certain level and close the game), it will still spit out a statistics file, and you're welcome to submit that as well. It just won't include statistics for any unfinished levels.

Other remarks:

This really is Game Maker territory. Game Maker excels at tile-based multi-level games where the same elements are reused throughout each stage. MMF2 does not. In fact, MMF2 has really poor support for global objects. This forced me to stuff all 15 levels into a single frame rather than have them on separate frames in order for me to retain my sanity (otherwise I'd have to retroactively apply changes to EVERY SINGLE LEVEL ONE BY ONE every time I wanted to change something). And then I tried squeezing 45 levels into the same frame but MMF2 really choked on that. I was forced to use a separate frame for each difficulty, thus any changes I might make in the future (if I can even be bothered) are not going to be global across difficulties unless I manually apply the changes to all difficulties. Also MMF2 is slow. Really slow. I think if I were to make a similar game again, I would stay far away from MMF2 and use something like Game Maker 5.3 or hell, even C++/Python/some other established programming language with Allegro/SFML instead. Klik just isn't cut out for this.

The music comes from an old module song, "galactic" by dark halo.

Event Created For: 
Made For: 
An event
Syndicate content